Smart Business AutomationOPTIMIZE · AUTOMATE · GROW
Engineer testing a VFD motor control panel with a multimeter
Service · TB-03 · Motion

VFD installation & motor control

Right-sized variable frequency drives, panels that stay cool in a Pakistani summer, and tuning that cuts energy bills on pumps, fans and conveyors.

Variable frequency drives, done properly

A variable frequency drive (VFD) controls the speed of an AC motor by changing the frequency of its supply. Used well, it gives soft starts, precise speed control and lower energy bills. Used badly, it trips, overheats and damages motor bearings. We handle VFD installation in Pakistan from start to finish, plus tuning and VFD repair on existing drives, so you get the first result, not the second. We work on Siemens SINAMICS, ABB drives, Danfoss drives and Delta VFD models, among others.

VFD services

Sizing and selection

We size the drive from the motor nameplate, the load type (constant torque or variable torque) and the duty cycle, then add margin for high ambient temperature, because panels in Punjab and Sindh regularly see 45 °C and above in summer.

Motor control panel design and wiring

Correct cable glands and shielded motor cable, line reactors or filters where harmonics matter, proper earthing and enough ventilation. Most drive failures we are called to are installation problems, not drive problems.

Tuning and control

Motor data entry and auto-tuning, ramp times matched to the load, PID control for constant pressure or flow, multi-speed presets, and control from the PLC over PROFINET, EtherNet/IP or Modbus.

Fault diagnosis and repair

Overcurrent, overvoltage, earth fault and overtemperature trips each point to a short list of causes. We read the fault history, test the motor and cable, and fix what is actually wrong.

Energy-saving upgrades

Pumps and fans that run at full speed against a throttled valve or damper waste a lot of power. Replacing the throttle with speed control is often the fastest-payback energy project in a plant.

Where VFDs pay off

  • Cooling-tower fans, boiler ID/FD fans and water pumps
  • Conveyors, centrifuges and mixers that need soft starts
  • Cranes and hoists that need smooth, controlled movement
  • Textile machines where speed sets product quality
Questions

FAQ

Straight answers to what plant owners and engineers ask us most.

How much energy can a VFD save?

On centrifugal pumps and fans the savings can be large, because power falls roughly with the cube of speed: running at 80% speed needs only about half the power. The real figure depends on how the load runs today, so we measure before we promise. Our VFD energy article explains the maths.

Which drive brands do you work with?

Siemens (SINAMICS), ABB, Danfoss, Delta and most other common brands found in Pakistani plants.

My VFD keeps tripping on overcurrent. Can you fix it?

Yes. Overcurrent trips usually come from acceleration times that are too short, wrong motor data, a failing motor or cable, or a mechanical problem. We check each in turn and fix the cause rather than just raising the limit.

Automated production line with PLC-controlled machines

Machine down or planning an upgrade?

Send us the PLC model and the problem. We reply within one working day.